重慶升降機液壓系統試壓的目的主要是檢查系統、回路的漏油、控制裝置和耐壓強度。系統的試壓一般都采取分級測試。每升一級，檢查一次，逐步升到規定的實驗壓力，這樣可以有效避免事故發生。下面給大家介紹一下升降平臺液壓系統試壓應該注意什么？

1、升降平臺試壓時系統的安全閥應調到所選定的實驗壓力值，在向系統打油時，應將液壓系統的放氣閥打開，待其空氣排除干凈后，方可關閉，同時將節流閥打開。
Hangzhou valve lift platform pressure test system should be transferred to the chosen experimental pressure when the system Dayou, you should open the release valve of the hydraulic system, let it be excluded clean air only after the close, while the throttle opening.

2、升降平臺如果在測試時，系統中出現異聲時，應立即停止，待查出原因并排除后，再進行測試。
Hangzhou lifting platform, if at the time of the test, different sound occurs when the system should be immediately stopped, and the exclusion of reason to be identified, and then tested.

3、升降平臺測試時，必須注意安全措施，并制定相應的預案。
Hangzhou lifting platform test, you must pay attention to safety measures, and to develop appropriate plans.